Free Project Advice

Talk to Lighting Experts

  • Project Design Services
  • Product Selection
  • Samples and Quotes!

Dynamic Tunable White Touch Series Remote


Touch Series Remote Control for Dynamic Tunable White LED strip lights

The Touch Series Dynamic White RF(Radio Frequency) remote enables you to control Dynamic Tunable White LED strip lights. The technology in these lights enable you to choose the exact color temperature (shade of white light) within the specified range of the lighting strip. 

Dynamic Tunable White LED Controller Installation


This remote is necessary to control Dynamic Tunable White LED Strips, act as a dimmer and it can separately adjust the brightness of the white and warm white in order to get a wide range of color temperature. Easily change the modes of the strip light to be bright white or warm white or any combination in between! Uses RF so there is no need for direct line of sight with the receiver.

Important Note:

The Dynamic Tunable LED strip light controllers will not work with the Zurik Dimmable Power supplies. You need to choose a non-dimmable LED power supply, like these

plug-in power supplies. 


Technical Parameters

  • Input voltage: DC 12-24V
  • Output channel: two signal output (10A/2 channel) = total 240W (12V DC) or 480W (24V DC)
  • There are two (-) terminals at 10 amps each, and one (+) terminal.
  • Functions: ON/OFF, Color temperature control and brightness control
  • Max remote distance: 50 ft without barriers
  • Controller: RF Dynamic Tunable White Touch Controller--Uses (2) AAA batteries
  • Radio Frequency: 433.92 MHz
  • Working Temperature: -30°C to +60°C
  • Dimensions for the receiver: 3 1/4" x 3 1/8" x 1 3/8" (83 mm * 79 mm * 33 mm)
  • Dimensions for the remote: 4 1/2" x 2 3/16" x 7/8" (113.5 mm * 55.5mm * 22.5mm)
  • Weight: 220 g (0.485 lbs)
  • New pairing mode function
  • Optimized wireless performance for less interference between remotes.

Frequently Asked Questions

Will the strip achieve full brightness when I turn the lights to the middle color setting (when both color temperatures of LED are on)?

Yes! We have built it that way for that specific purpose. Most control systems for Dynamic Tunable lights only achieve half brightness when the middle color setting is applied. Our remotes have been built with a brightness curve that increases mid-range, enabling you to get the full brightness out of your strips.  

Will the remote remember what dimming level I was on?

 Yes. Whether you turn the strips off from the remote or through a wall switch, the controller will remember the exact dimming level you had the strips previously. 

Can I have more than two remotes in one area?

Yes, you can. Each receiver can be matched to five remote controllers. We have optimized the wireless performance of this product for less interference between two remotes. However, we have rarely seen that there is some RF interference from other remote. If this happens, you need to turn off one set of lights while changing the others. To eliminate this, get a signal amplifier so you can control long distance Dynamic Tunable White strip light runs with one remote control.

Related Products

Enter Your Email for an Instant Coupon and Design Guide for Your Project